CA Dynam for VSE User Guide

Disk File Maintenance Utilities
Using the REORG command, restore the (G#12) version as the (G-1) version
of ALT.STOCK:
REORG 'STOCK(G#12)' CATALOG GDS=REPLACE NEWDSN='ALT.*(G-1)'
CA Dynam Catalog
Before: STOCK - NGEN=3 - G#14 -> G#13 -> G#12
ALT.STOCK - NGEN=3 - G#76 -> G#75 -> G#74
After: STOCK - NGEN=3 - G#14 -> G#13 -> G#12
ALT.STOCK - NGEN=3 - G#76 -> G#75 -> G#74
|
+------ G#12 from backup
Note that the result would be the same for NEWDSN=ALT.STOCK(G-1).
Using the REORG command, restore the file NOT.A.GDS as the current version
of STOCK:
REORG 'NOT.A.GDS' CATALOG GDS=NEW NEWDSN='STOCK'
CA Dynam Catalog
Before: STOCK - NGEN=3 - G#14 -> G#13 -> G#12
After: STOCK - NGEN=3 - G#15 -> G#14 -> G#13
|
+------------- NOT.A.GDS from backup
Note that GDS= is required in the command because the target file is a GDS,
even though the file selected from the tape is not.
Using the REORG command, restore version (G#13) of STOCK as file
NOT.A.GDS:
REORG 'STOCK(G-1)' CATALOG NEWDSN='NOT.A.GDS'
CA Dynam Catalog
Before: STOCK - NGEN=3 - G#14 -> G#13 -> G#12
After: STOCK - NGEN=3 - G#14 -> G#13 -> G#12
NOT.A.GDS - file
|
+----------- STOCK(G#13) from backup
Note that GDS= is omitted from the command because the target file is not a
GDS even though the file selected from the tape is.
Using the REORG command, restore the file NOT.A.GDS as file
ALSO.NOT.A.GDS:
REORG 'NOT.A.GDS' NEWDSN='ALSO.*' CATALOG
(CATALOG is optional)
5–36 User Guide