CA Dynam for VSE User Guide

TLBL/DLBL Extensions
−
−
−
Total length of file-id, including generation and options, cannot exceed
59.
Relative generation must precede option codes.
Parentheses are supported.
• If the actual data set name length (after the options are stripped) is
greater than 17, the last 17 significant characters are written to the HDR1
label on the tape.
date
Expiration date (yy/ddd or yyyy/ddd) or number of days retention (nnnn). This
date is calculated using the greatest number of retention days specified in any
one of the following places:
• The catalog for the data set
• The TLBL
• The default from the DYNAM/T option record
volser
volseq
fileseq
gen
Gen=nnn
Topt
Volume serial number of first input volume. Omit for output.
Volume sequence number of specific volume of multivolume data set. Omit for
output.
The file sequence number field is not used by CA DYNAM/T and should be
omitted in all cases. The multifile data set control provided by CA DYNAM/T is
based upon the data set name and control records in the Catalog.
Specific version of input data set; 1-4 digits. Place generation number here
instead of within file-id if the file-id is too large or contains special symbols.
Specific, absolute generation number assigned to a new version of a data set.
Entering this generation number lets you to access a particular data set
version for input. Place the absolute generation number here instead of within
file-id if the file-id is too large or contains special symbols. Processing options
must be separated by commas. If the first option is a keyword and IBM
options are omitted, at least 1 comma after file-id is required; otherwise, at
least 2 commas are needed.
CA Dynam/T numeric processing options. Place option codes here instead of
within file-id if the file-id is too large or contains special symbols.
1 Rewind at CLOSE
2 Unload at CLOSE
4 Release at CLOSE
8 Hold logical unit assignment
16 Drop TLBL at CLOSE
32 No rewind at CLOSE
1–10 User Guide