CA Dynam for VSE User Guide

Disk File Maintenance Utilities
[ EXCLUDE= ['file-id'|' file-id*']]
[ PERM ]
[ RETAIN ]
[ UNEXPIRED ]
DUMP { 'file-id' } { POOL=poolid } [ EXPIRE=[yy/ddd|yyyy/ddd] ]
{ 'file-id*' } { VOL=volid } [ EXCLUDE= [' file-id'|' file-id*']]
[ PERM ]
[ RETAIN ]
[ UNEXPIRED ]
DUMP { 'file-id' }CATALOG
{ 'file-id*'}CATALOG [ EXCLUDE= [' file-id'|' file-id*']]
Required parameter
These operands are mutually exclusive.
'file-id'
'file-id*'
Identifies the specific file ID for transfer to tape. You can select a specific
generation by identifying the relative generation number or absolute
generation number in parentheses, respectively (G-nn) or (G#nn). If a specific
generation is not specified, then the most current generation is accessed.
Identifies the group of file IDs for transfer to tape.
Note: If you specify file-id or file-id*, you must also specify a VOL=volid or
POOL=poolid.
VOL=volser
CATALOG
Indicates the disk volume from which all files are selected for transfer to tape.
The volser must be specified as a six-character real volume serial number (a
pool or generic volume serial number is not allowed here). This is a full volume
dump.
Specifies to DYNUTIL that only files with existing catalog versions should be
dumped. Specifying CATALOG on the dump action dumps all files with a
matching file-ID if they are found in the CATALOG only. DYNUTIL supports the
catalog option when used with the DUMP command.
Required Parameter for a file-id or file-id* Dump
Specify either VOL=volid or POOL=poolid.
POOL=poolid
VOL=volid
Specifies the six-character serial number that identifies a pool of disk volumes
from which to dump the indicated files. The pool is defined in the COMPOOL
option record.
Specifies the six-character serial number of the disk volume, such as SYSWK4,
or collection of disk volumes, such as SYS***, from which to dump the
indicated files.
5–22 User Guide