CA Dynam for VSE User Guide

Disk File Maintenance Utilities
VOL=volser
Identifies the six-character volume serial number of the disk volume on which
the file resides. You can specify a generic volume serial number.
Required parameter for a file-id display
The following operands are mutually exclusive:
CATALOG
POOL=poolid
VOL=volid
Specifies that only the Catalog is to be searched for the file.
Specifies a virtual serial number that has been defined as a CA Dynam/D disk
pool using the COMPOOL option record.
Identifies the six-character volume serial number of the disk volume on which
the file resides. This can be specified as a generic volume serial number when
suffixed with asterisks.
Required parameter for a VOL=display
All of the following operands are mutually exclusive:
EXTENT=(cc1,hh1,cc
2,hh2)
cc1,hh1 specifies the cylinder and head address at which to begin the
display.
cc2,hh2 specifies the ending disk address. If you do not supply the ending
address, cc2,hh2 is set to cc1,hh1, displaying only one track.
PBN=(pbn1,pbn2, cisize)
pbn1 specifies the physical block number at which to begin the display.
pbn2 specifies the ending pbn. If you do not supply the ending address, pbn2
is set to pbn1, displaying only one CI.
cisize specifies the control interval size. If you omit it, 512 is used.
If you supply a cisize, the pbn2 operand is required (can be equal to pbn1 if
you want to display only one CI).
Note: PBN can also be used for CKD devices and is then interpreted as a
relative track number.
VTOC
Specifies that the entire VTOC is to be displayed.
The Option List shown that follows applies to both file-id and VOL=. You can
specify any or all operands in this list.
ALL
CHAR
Indicates that the operands CHAR, HA, COUNT, and HEX are all to be used.
Specifies that each record is to be displayed in character format.
5–20 User Guide