CA Dynam for VSE User Guide

Specifying the SET Command
PERM|TEMP
PERM is the default if you specify neither PERM nor TEMP.
PERM
TEMP
Indicates that the CONSOLE= and PRINT= options on this
SET command are to remain in effect for the duration of
the processing session, unless overridden (for a single
job) by a temporary SET command or changed by a
subsequent SET command with the PERM option.
Indicates that the CONSOLE= and PRINT= options on this
SET command are to remain in effect for the duration of
this job only or until changed by a subsequent SET
command.
PRINT=
Relates to the printing of CA Dynam/D informative messages. The value set
for PRINT takes precedence over any option codes defined for a file. For
example, if PRINT=OFF is specified, the I option code for a file will be ignored.
The options AFTER and BOTH determine the carriage control position for
printing messages on SYSLST. They protect CA Dynam/D messages from
being overwritten by user programs which issue WRITE statements without
ADVANCE instructions.
AFTER
BOTH
OFF
ON
NULL
Prints a CA Dynam/D message after breaking to the next
print line.
Breaks to a new line, prints a CA Dynam/D message, and
then breaks to the next line.
Suppresses the messages which are directed to SYSLST
through the CA Dynam/D generation option.
Prints CA Dynam/D informative messages on SYSLST,
overriding PRINT=OFF which suppresses them.
Resets the option to that specified in the DYNAM/D option
record.
Chapter 4: Disk File Management 4–51