CA Dynam for VSE User Guide

Start and Deactivate CA Dynam
Start and Deactivate CA Dynam
This section describes how to start and deactivate CA Dynam.
Start CA Dynam
To start the CA Dynam system, complete the following steps:
1. IPL your operating system.
2. Run the startup program, CASAUTIL, from an ASI PROC to initialize CA
Dynam.
CASAUTIL can be run at any time (not just from an ASI PROC), but the system
can protect data sets only when active. Thus, we recommend that it be started
as early in the IPL procedure as possible. For more information about
CASAUTIL, see the Programming Guide.
After activation, all the subsets that comprise the complete CA Dynam family
remain active.
Deactivate CA Dynam
To temporarily deactivate one or more of the subset systems, the profile phase
for the subsets can be deleted from the core image library or renamed, and an
IPL performed. Alternatively, through the use of CASAUTIL START statements,
various subsets of the CA Dynam family can be activated while leaving others
inactive, without requiring deletion or renaming of any library entries. For
more information, see the Programming Guide.
CA Dynam Extended Operator Communication Facility
To implement extended operator communications support, CA Dynam provides
an interface through attention routine (AR) commands. You can enter AR
commands only when CA Dynam is active; the commands are effective
immediately. Commands relevant to particular products are, of course, only
active if that product is installed.
CA-CP | CP
Passes a VM command to the CP processor and displays the returned
message. For example:
CA-CP QUERY STORAGE
CADS335 STORAGE = 4096K
1–4 User Guide