CA Dynam for VSE User Guide

Vault Location Control Program—TDYNVLT
INCLVLT=(x,x,.....x,x) Selects the vault locations to be reported on. If you omit this operand,
TDYNVLT reports on the following:
• All vault locations, unless EXCLVLT is defined
• All vault locations except those defined by EXCLVLT
EXCLVLT=(x,x,.....x,x) Indicates which vault locations to leave out of the report. If you omit this
operand, TDYNVLT reports on the following:
• All vault locations, unless INCLVLT is defined
• Only vault locations defined in INCLVLT
MDSN=
Determines which data set names of a multifile volume are to be listed on the
report.
YES
NO
Prints all the data set names of a multifile volume.
Prints only the first data set name.
The default is NO. If the report sequence is based on data set name, it is
always based on the first data set name of a multifile.
EXTRACT
Creates a file (with a ddname of CAIEXTR), that contains a list of all the tapes
in the Catalog.
This command should be executed only once.
Note: The TDYNIBM program EJECT command can be used to read the
CAIEXTR file and eject volumes from the 3494 Tape Library. For more
information, see IBM 3494 Tape Library Interface.
Inventory Report
Location Inventory (Verification) Report (TDYNVLT-05)
Lists all tapes in each vault. TDYNVLT can generate this report for all or
specific vault locations. If the report is by volume serial number, it lists only
the first data set of a multifile, unless you specify MDSN=YES.
3–50 User Guide