CA Dynam for VSE User Guide

Vault Location Control Program—TDYNVLT
Establishing Vault Locations
To establish the desired location for each version of a data set, you can do the
following:
• Specify a location for each of the first 999 versions.
• Specify up to 26 different locations.
• Attach to each location, a 77-character description to be printed on the
vault reports.
If a version does not have a specified vault location, TDYNVLT uses the data
set's default vault location.
You can specify the starting version of a data set for the vault location by
including the VLTSEQ=nnn parameter with VLTLOC. Vault sequencing lets you
define which of up to 999 versions of a data set has vault control. VLTSEQ
must be used with VLTLOC on a DYNCAT ALTER command.
You can also define slot numbers within all vault locations, except vault A.
These slot numbers enable you to further control the vault locations. For each
vault, you can do the following:
• Define up to 10 ranges of slot numbers, with a maximum of 65,536 slots
per range.
• Define and delete slot-number ranges using the DYNCAT program.
Defining Slots
To define slots within vaults, use the DYNCAT VAULT control statement, as
follows:
VAULT VLTLOC=x [DESC='xxxxx'] SLOTS=(x1,y1)
You can define up to 10 ranges of slot numbers, but only one range per
statement. Each slot range must be uniquely associated with a VLTLOC=
parameter and a VAULT command. For example,
VAULT VLTLOC=B SLOTS=(100,200)
VAULT VLTLOC=B SLOTS=(300,400)
VAULT VLTLOC=B SLOTS=(500,600)
VAULT VLTLOC=C SLOTS=(50,100)
To place slot numbers within your CA Dynam Catalog, run the following as the
first VAULT movement after the conversion:
// JOB TDYNVLT
// DLBL WORK1,'WORK.01'
// EXTENT SYS001..........
// ASSGN SYS001,cuu
3–46 User Guide