CA Dynam for VSE User Guide

Reporting on Tape Files
Important! Run the LIST NEW report only when there are no tape files being
created in other partitions.
PASSWORD=
Generates a list of all data sets which are password-protected, along with the
associated password.
Eight-character catalog password enclosed in single quotation marks.
SCRATCH
VOL=
Generates a listing of all scratch tapes in the library in volume serial number
sequence.
Generates a listing of all active tapes or tapes selected by volume serial
number. The list is in volume serial number sequence. Valid entries are:
1- to 6-character volume serial number
ALL - for all active tapes
Example:
// JOB PRINT VARIOUS REPORTS
// ASSGN SYS001,130 DISK WORK FILE
// DLBL WORK1,'WORKAREA',0,SD
// EXTENT SYS001,...
// EXEC TDYNUTL,SIZE=128K
LIST ALL
LIST DSN='ALL' or LIST DSN=ALL
LIST DSN='FILE NAME'
LIST VOL=ALL
LIST VOL=234
LIST NEW
LIST SCRATCH
/*
/&
This job stream generates the following listings:
• All tapes in volume serial number sequence
• All data sets in data set name sequence
• All tapes associated with the file FILE NAME in ascending sequence by
version number (the current version is listed first)
• All active tapes in volume serial number sequence
• Volume serial number 234
• Two lists of all tapes cataloged in the library since the last time this
function was performed. One list is in volume serial number sequence and
the other one in Data Set Name sequence
• All scratch tapes in the library in volume serial number sequence
3–42 User Guide