CA Dynam for VSE User Guide

Reporting on Tape Files
FORMAT Command
The FORMAT command sets the number of lines and the line spacing on any of
the reports generated by TDYNUTL. The FORMAT control statement is
free-form with the command FORMAT followed by two required positional
parameters. The two parameters are separated by a comma.
Positional parameter-1 Two-digit number from 10 to 99 that specifies the number of lines to be
printed on a report page.
Positional parameter-2 One-digit number from 1 to 3 that specifies the number of lines to space
between print lines.
Example:
// JOB LIST OF ALL TAPES DOUBLE SPACED
// ASSGN SYS001,130 DISK WORK FILE
// DLBL WORK1,'WORKAREA',0,SD
// EXTENT SYS001,...
// EXEC TDYNUTL,SIZE=128K
FORMAT 28,2
LIST ALL
/*
/&
Note: Make sure that the number of lines and the line spacing are
compatible—for instance, if double spacing and 60 lines are specified, there
will be a page overrun.
LIST Command
The LIST function creates various reports that are output to SYSLST. You
indicate the type of report through one or more of the keyword or positional
parameters. LIST has a free-form format. The operation code LIST is followed
by one or more of these keyword or positional parameters:
ALL
DSN=
Generates a listing of all volumes in the library in volume serial number
sequence.
Generates a listing of all or selected data sets in the library. Valid entries are:
1- to 44-character data set name enclosed in single quotation marks
ALL - for all data sets
NEW
Generates two listings of all tapes that have been cataloged manually or by
the system since the last time the LIST NEW function was executed. One
listing is in volume serial number sequence, and the other is in data set name
sequence.
Chapter 3: Supporting Tape File Management 3–41