CA Dynam for VSE User Guide

Reporting on Tape Files
STD= {YES|NO }
Optional. Indicates whether the label information is in standard labels.
YES
NO
END=YES
You must include END=YES as the last statement of the PULLTAB option
record. END=YES causes the start of the TDYNPULT phase generation.
Coding the PULLTAB Option Record
The following job stream is used to generate and catalog the phase TDYNPULT.
At installation time, the source book called TDYNPULT is cataloged into
Sublibrary A. An example of the assembly is contained in the source book
CAYDMACS in Sublibrary Z.
// JOB TDYNPULT CATALOG THE TDYNPULL PULL TABLE
// OPTION CATAL
PHASE TDYNPULT,*
// EXEC ASSEMBLY
PULLTAB TYPE=BEGIN
PULLTAB IOIND=O,JOB=,DTF=SORTOUT,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN1,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN2,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN3,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN4,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN5,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN6,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN7,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN8,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=SORTIN9,PHASE=SORT,DSN=,
STD=NO
PULLTAB IOIND=I,JOB=,DTF=UIN,PHASE=,DSN=,STD=NO
PULLTAB IOIND=O,JOB=,DTF=UOUT,PHASE=,DSN=,STD=NO
PULLTAB END=YES
END
/*
// EXEC LNKEDT
/&
C
C
C
C
C
C
C
C
C
C
Chapter 3: Supporting Tape File Management 3–37