CA Dynam for VSE User Guide

Reporting on Tape Files
UNCONTROLLED INPUT
UNCONTROLLED OUTPUT
VOLSER VOLSER VOLSER
A TLBL/DLBL contains a data set name
that could not be found in the CA Dynam
Catalog, but TDYNPULL determined that
this file is input.
A TLBL/DLBL contains a data set name
that could not be found in the CA Dynam
Catalog, but TDYNPULL determined that
this file is output.
These are the input volumes required for
this file. They are also summarized at
EOJ.
DYNPULL PULLTAB Option Record
TDYNPULL uses the PULLTAB option record to determine the following:
• The status (input/output) of a particular file created by a specific job,
phase, or both.
• Whether a particular job or phase uses TLBL/DLBL information from
partition or standard labels; whether a particular job and phase use
TLBL/DLBL information from partition or standard labels.
PULLTAB Parameters
Standard IBM syntax rules for assembling an option record apply. The
parameters available for the PULLTAB option record are detailed in the
following table:
IOIND= {I|O }
Specifies how the file is used:
I
O
- as input
- for output
JOB=jobname
DTF=dtfname
PHASE=phasename
DSN=dsn
Optional. Identifies the job name you want to associate with this file. (Follow
IBM syntax rules.)
Supplies the dtf name. (Follow IBM syntax rules.)
Optional. Indicates the phase name of the phase you want to associate with
this file. (Follow IBM syntax rules.)
Required when specifying STD=YES. Specifies the data set name. The data set
name can contain CA Dynam/T options with a maximum length of 44
characters (59 including options).
3–36 User Guide