CA Dynam for VSE User Guide

Reporting on Tape Files
Example:
TDYNLIST input stream
// JOB TDYNLIST GENERATE CA Dynam/T PULL LIST
// DLBL WORK1,'WORK.01'
// EXTENT SYS001,. . .extent information. . .
// EXEC TDYNLIST,SIZE=128k
TITLE=PAYROLL SYSTEM PULL LIST
STEP=EDIT TRANSACTIONS
DN='PR TRANS',SCRATCH,NOTE=EDITED PAYROLL TRANSACTIONS
STEP=UPDATE PAYROLL MASTER
DN='PR MASTER',NOTE=INPUT PAYROLL MASTER
DN='PR MASTER',SCRATCH
DN='PR TRANS',NEW
NOTE=ANY SPECIAL HANDLING INSTRUCTIONS MAY APPEAR HERE
ROUTE
/*
/&
JCL-driven Pull-list Utility—TDYNPULL
TDYNPULL generates a list of the volume serial numbers and total number of
scratch tapes needed for any job stream you submit. Any combination of CA
Dynam DLBL and TLBL statements are accepted along with the standard VSE
JCL.
TDYNPULL accesses the CA Dynam Catalog in read-only mode. It requires the
use of temporary external storage, and a dtfname of WORK1 on SYS001, for
sorting. Output is directed to SYSLST.
You can execute TDYNPULL from the console or from SYSRDR. Acceptance of
input and end of input, varies as follows, depending on where TDYNPULL is
executed from:
• If executed from the console—Input is accepted from SYSLOG; the end of
input is denoted by a null response to the CADT650I message.
• If executed from SYSRDR—Input is accepted from SYSIPT; a statement
(starting in position 1) containing the words TDYNPULL END signals the
end of input.
A report line is produced for each valid input statement that follows:
// JOB
// EXEC
// DLBL
// TLBL
Chapter 3: Supporting Tape File Management 3–33