CA Dynam for VSE User Guide

Controlling POWER Job Accounting Tapes
Controlling POWER Job Accounting Tapes
In order for CA Dynam/T to control POWER job accounting tapes, the Z option
must be specified on the TLBL in the POWER partition, the partition standard
label or the standard label, as follows:
// TLBL dtfname,'dsn,Z'
To create the tape, issue the following POWER PACCOUNT command with the
dtfname as specified in the TLBL:
{PACCOUNT|J } tapeaddr,,dtfname
Note: Do not specify a density, it will be automatically assigned by the
CA Dynam catalog.
Enforcing Volume Serial Number Standards
CA Dynam/T enables you to automatically enforce standards for volume serial
numbers. You can require that all volume serial numbers introduced into the
CA Dynam Catalog are numeric or fall within a certain range by using the
VOLSER parameter of the DYNAM/T option record.
If a nonstandard serial number is introduced into the CA Dynam Catalog, it
causes one of the following:
• An error, if a DYNCAT command is being used
• The operator response to be ignored if the operator is initializing a tape
using the inline initialization facility
For more information about coding and using the DYNAM/T option record, see
the Programming Guide.
Specifying the SET Command
The SET command lets you control various options of the CA Dynam/T system.
It can be entered either through the system operator's console or along with
other JCL in an input job stream. The command affects only the partition in
which it is entered.
2–82 User Guide