ABB i-bus® EIB Universal Interfaces US/U 4.2 US/U ... - WindowMaster
ABB i-bus® EIB Universal Interfaces US/U 4.2 US/U ... - WindowMaster
ABB i-bus® EIB Universal Interfaces US/U 4.2 US/U ... - WindowMaster
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>ABB</strong> i-bus ® <strong>EIB</strong><br />
4.10 Function: “Control LED”<br />
<strong>Universal</strong> <strong>Interfaces</strong><br />
<strong>US</strong>/U 2.2, GH Q631 0074 R0111<br />
<strong>US</strong>/U <strong>4.2</strong>, GH Q631 0070 R0111<br />
The following section describes all the parameters and objects which are<br />
visible if the input is operated with the function “Control LED”. It is possible for<br />
example to confirm an operation via an LED.<br />
4.10.1 Parameters<br />
Parameter window for LED function = “switch ON/OFF”<br />
Parameter window for LED function = “Flashing”<br />
...<br />
Parameter: “LED functionality”<br />
This parameter defines whether the output should control the LED permanently<br />
(“switch ON/OFF”) or whether it should flash. The corresponding<br />
objects “LED, switching” or “LED, flashing” are enabled.<br />
Parameter: “LED is switched ON, if”<br />
This parameter is visible if the LED function has been set to “switch<br />
ON/OFF”. It can be defined which state the object “LED, switching” must have<br />
so that the LED is switched on.<br />
Parameter: “LED flashes, if”<br />
This parameter is visible if the LED function “Flashing” has been set.<br />
It can be defined which state the object “LED, flashing” must have so that the<br />
flashing of the LED is active.<br />
31