ABB i-bus® EIB Universal Interfaces US/U 4.2 US/U ... - WindowMaster

Contents
Seite
5 Special functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
5.1 Debounce time and minimum operation time . . . . . . . . . . . . . . . . 41
5.2 Limit telegram rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
5.3 Cyclical sending . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
5.4 Dimming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
5.5 Scene control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
5.6 Control of electronic relay (heating actuator) . . . . . . . . . . . . . . . . 43
5.7 Switching sequences . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
5.8 Pulse counter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46
5.9 Behaviour during bus voltage failure . . . . . . . . . . . . . . . . . . . . . . . 47
5.10 Behaviour after bus voltage recovery . . . . . . . . . . . . . . . . . . . . . . 47
6 Planning and application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
6.1 1 push button operation with central function (switch lamp) . . . . . 49
6.2 Operation of dimmable lighting . . . . . . . . . . . . . . . . . . . . . . . . . . . 50
6.3 Operation of shutters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
6.4 Controlling scenes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53
6.5 Controlling a heating valve . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
6.6 Switching the lighting in sequence . . . . . . . . . . . . . . . . . . . . . . . . 57
6.7 Switching the lighting via multiple push button operation . . . . . . . 59
6.8 Counting energy values . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
7 Appendix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61
7.1 Table of grey code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61
7.2 Ordering information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62
This manual describes the function of the universal interfaces US/U 2.2 and
US/U 4.2 with the application program “Binary Input Display Heat xf/1”.
Subject to technical changes. Errors excepted
Exclusion of liability:
Despite checking that the contents of this document correspond to the hardware
and software, deviations cannot be ruled out completely. We therefore
cannot accept liability for this. Any necessary corrections will be integrated in
new versions of the manual.
Please tell us about any suggestions for improvement you may have.
2