ABB i-bus® EIB Universal Interfaces US/U 4.2 US/U ... - WindowMaster

ABB i-bus ® EIB
Universal Interfaces
US/U 2.2, GH Q631 0074 R0111
US/U 4.2, GH Q631 0070 R0111
Parameter: “’Telegr. “STOP/lamella adj.’ is repeated every”
This parameter is visible in operating modes in which the object “Telegr.
STOP/lamella adj.” is sent cyclically on the bus during a long operation.
The interval between two telegrams is set here.
Parameter: “Debounce time”
The debounce prevents unwanted multiple operation of the input e.g. by
bouncing of the contacts. Refer to section 5.1 for the exact function of this
parameter.
4.6.2 Communications objects
Object: “Telegr. shutter UP/DOWN”, 1 bit (EIS 7)
This communication object sends a shutter movement command (UP or
DOWN) on the bus. The device also recognises movement commands
of another sensor via the receipt of telegrams.
Telegram value “0” UP
“1” DOWN
Object: “Telegr. STOP/lamella adj.”, 1 bit (EIS 7)
This communication object sends a STOP or lamella adjustment telegram.
Telegram value “0” STOP / lamella UP
“1” STOP / lamella DOWN
Object: “Upper limit position”, 1 bit (EIS 1)
The shutter actuator reports via this object whether it is located in the upper
limit position (“Blind open”).
The object is intended for 1 push button operation.
Telegram value “0” No upper limit position
“1” Upper limit position
Object: “Lower limit position”, 1 bit (EIS 1)
The shutter actuator reports via this object whether it is located in the lower
limit position (“Blind closed”).
The object is intended for 1 push button operation.
Telegram value “0” No lower limit position
“1” Lower limit position
19