EMB-500 - Embraer

GROUND HANDLING AND
SERVICING HANDBOOK
HARD COPY IS UNCONTROLLED. ONCE PRINTED, THIS PAGE MUST NOT BE RETAINED FOR FUTURE REFERENCE.
BEFORE USING, MAKE SURE THIS HARD COPY IS THE LATEST ISSUE.
(f) Lightly apply it to the surface with a soft-bristle brush.
(g) Do the operation again until the surface is fully clean.
NOTE: • Do not wet the carpet too much.
• Clean from the edge of the spot to prevent too much
spread.
(h) When the spot is removed, apply pressure with paper towels or dry
absorbent cloth to blot excessive moisture.
(i) Use a clean cloth soaked in warm water again from the edge to the
center.
NOTE: Do not rub the carpet.
(j) Apply pressure with paper towels or dry absorbent cloth to blot excessive
moisture.
(k) After the removal of the spots, clean the surface.
NOTE: Do not walk on moist areas of the carpet.
(3) Remove the wool and sink spot as follows:
CAUTION: FOR SILK CLEANING, AVOID USING WATER AND
WATER-BASED CLEANERS. USE DRY CLEANING
AGENTS ONLY.
(a) Beverage:
NOTE: Do not use metal bristles.
1. Use a dry cloth towel to blot the spot.
2. Apply pressure moderately. If the spot continues, use club soda to
make the area moist.
3. Blot until the spot is removed.
4. Use the CAPTURE product to remove residual discoloration.
NOTE: Follow manufacturer's instructions.
(b) Food spill:
1. Remove as much solid matter as possible.
2. Blot up as much liquid matter as possible.
3. For a wool spot, use a shop wipe soaked in club soda to make the
area moist and blot up again.
4. Use CAPTURE water based residual solution.
CAUTION: DO NOT OVER-SPRAY THE CARPET. APPLY ZEP-X-
OUT TO THE TOWEL THEN GENTLY WORK INTO
CARPET.
5. Use Zep-X-out II for grease or oil.
NOTE: Use the manufacturer's instructions.
EFFECTIVITY: ALL
12-23-00-100-802-A/300
Page 308
Rev.06 - OCT 09/09
Copyright © by EMBRAER S.A. - All rights reserved - See title page for details.