Emotron FDU 2.0 Variable Speed Drive

2.2 Stand-alone units
The VSD must be mounted in a vertical position against a
flat surface. Use the template (delivered together with the
VSD) to mark out the position of the fixing holes.
Fig. 6 Variable speed drive mounting models 003 to 1500
2.2.1 Cooling
Fig. 6 shows the minimum free space required around the
VSD for the models 003 to 1500 in order to guarantee adequate
cooling. Because the fans blow the air from the bottom
to the top it is advisable not to position an air inlet
immediately above an air outlet.
The following minimum separation between two variable
speed drives, or a VSD and a non-dissipating wall must be
maintained. Valid if free space on opposite side.
Table 4
Mounting and cooling
Fig. 5 Lifting VSD model -300 to -1500
FDU-FDU
(mm)
FDU-wall,
wall-one
side
(mm)
003-018 026-046 090-250 300-1500
cabinet
a 200 200 200 100
b 200 200 200 0
c 0 0 0 0
d 0 0 0 0
a 100 100 100 100
b 100 100 100 0
c 0 0 0 0
d 0 0 0 0
NOTE: When a 300 to 1500 model is placed between two
walls, a minimum distance at each side of 200 mm must
be maintained.
10 Mounting Emotron AB 01-4428-01r2