Emotron MSF 2.0 Fieldbus Option

More documents

Recommendations

Info

Safety Instruction manual It is important to be familiar with the softstarter to fully understand this instruction manual. Technically qualified personnel Installation, commissioning, demounting, making measurements, etc. of or on the <strong>Emotron</strong> products may only be carried out by personnel technically qualified for the task. Installation The installation must be made by authorised personnel and must be made according to the local standards. Opening the softstarter DANGER! ALWAYS SWITCH OFF THE MAINS VOLTAGE BEFORE OPENING THE UNIT. Always take adequate precautions before opening the softstarter. Although the connections for the control signals and the jumpers are isolated from the mains voltage. Always take adequate precautions before opening the softstarter. EMC Regulations EMC regulations must be followed to fulfil the EMC standards. CG Drives & Automation 01-5927-01r0 Safety
Safety CG Drives & Automation 01-5927-01r0
Page 1 and 2: Emotron MSF 2.0 Fieldbus Option Ins
Page 6 and 7: Contents Safety ...................
Page 8 and 9: 1. Quick Set-up Following flowchart
Page 10 and 11: 2. General 2.1 Introduction The Fie
Page 12 and 13: 3. FieldBus I/O 3.1 Introduction Th
Page 14 and 15: 3.5.2 LED indication Four LED´s in
Page 16 and 17: 4. ProfiBus - Dp 4.1 Introduction P
Page 18 and 19: 5. DeviceNet 5.1 Introduction Devic
Page 20 and 21: 5.2.6 Led indication Table 5 LED in
Page 22 and 23: 6. RS-232 6.1 EmoSoftCom This conne
Page 24 and 25: 7. Emotron MSF 2.0 NOTE: This chapt
Page 26 and 27: 7.3 Installation in Emotron MSF-170
Page 28 and 29: CG Drives & Automation 01-5927-01r0
Page 30 and 31: Serial comm. unit address [270] 2 7
Page 32 and 33: 2 7 3 Setting o F F Serial comm. co
Page 34 and 35: 7.8 Map 7.8.1 Definitions This is t
Page 36 and 37: 7.8.3 Response Bit Output from MSF
Page 38 and 39: Bit Output from MSF Setting Comment
Page 40: CG Drives & Automation Sweden AB M

Emotron MSF 2.0 Fieldbus Option

Create successful ePaper yourself

Delete template?

Save as template?