Emotron MSF 2.0 Fieldbus Option

More documents

Recommendations

Info

6. RS-232 6.1 EmoSoftCom This connection is mainly provided for the EmoSoftCom, a PC program. EmoSoftCom is a utility that will help customers to monitor and configure the MSF 2.0 softstarter. Fig. 6 RS-232 communication. 6.2 Modbus RTU and RS-232 For more information about this possibility, please see the Serial Communication Option Instruction Manual, which can be obtained from CG Drives & Automation. 6.3 Modes To activate RS-232 communication mode, jumper must be in the RS-232 position. When jumper is in the FieldBus mode it is not possible to communicate with RS-232 and vice versa. CG Drives & Automation 01-5927-01r0 RS-232 17
Jumper Fieldbus RS-232 RS-232 Fig. 7 RS-232 configuration. 6.4 RS-232 Connection Table 6 RS-232 Connection D-sub Description 2 Tx 3 Rx 5 GND 18 RS-232 CG Drives & Automation 01-5927-01r0
Page 1 and 2: Emotron MSF 2.0 Fieldbus Option Ins
Page 4 and 5: Safety Instruction manual It is imp
Page 6 and 7: Contents Safety ...................
Page 8 and 9: 1. Quick Set-up Following flowchart
Page 10 and 11: 2. General 2.1 Introduction The Fie
Page 12 and 13: 3. FieldBus I/O 3.1 Introduction Th
Page 14 and 15: 3.5.2 LED indication Four LED´s in
Page 16 and 17: 4. ProfiBus - Dp 4.1 Introduction P
Page 18 and 19: 5. DeviceNet 5.1 Introduction Devic
Page 20 and 21: 5.2.6 Led indication Table 5 LED in
Page 24 and 25: 7. Emotron MSF 2.0 NOTE: This chapt
Page 26 and 27: 7.3 Installation in Emotron MSF-170
Page 28 and 29: CG Drives & Automation 01-5927-01r0
Page 30 and 31: Serial comm. unit address [270] 2 7
Page 32 and 33: 2 7 3 Setting o F F Serial comm. co
Page 34 and 35: 7.8 Map 7.8.1 Definitions This is t
Page 36 and 37: 7.8.3 Response Bit Output from MSF
Page 38 and 39: Bit Output from MSF Setting Comment
Page 40: CG Drives & Automation Sweden AB M

Emotron MSF 2.0 Fieldbus Option

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?