Emotron MSF 2.0 Fieldbus Option
Emotron MSF 2.0 Fieldbus Option Emotron MSF 2.0 Fieldbus Option
3.5.2 LED indication Four LED´s indicates what status the FieldBus I/O Option have. LED 1 and 2 are only for internal use at production. LED 3 (green) indicates that the FieldBus communication is working and running. LED 4 (red) indicates that external communication is broken. LED 3 and 4 (red and green) indicates that the FieldBus I/O Option is trying to achieve internal communication with the product. This state is seen when the product is started. If the product is not correct set the Fieldbus I/O Option will remain in this state. 3.6 Recommendation We suggest that installation, cables and connectors must be followed as specified by each fieldbus organisation. CG Drives & Automation 01-5927-01r0 FieldBus I/O 9
10 FieldBus I/O CG Drives & Automation 01-5927-01r0
- Page 1 and 2: Emotron MSF 2.0 Fieldbus Option Ins
- Page 4 and 5: Safety Instruction manual It is imp
- Page 6 and 7: Contents Safety ...................
- Page 8 and 9: 1. Quick Set-up Following flowchart
- Page 10 and 11: 2. General 2.1 Introduction The Fie
- Page 12 and 13: 3. FieldBus I/O 3.1 Introduction Th
- Page 16 and 17: 4. ProfiBus - Dp 4.1 Introduction P
- Page 18 and 19: 5. DeviceNet 5.1 Introduction Devic
- Page 20 and 21: 5.2.6 Led indication Table 5 LED in
- Page 22 and 23: 6. RS-232 6.1 EmoSoftCom This conne
- Page 24 and 25: 7. Emotron MSF 2.0 NOTE: This chapt
- Page 26 and 27: 7.3 Installation in Emotron MSF-170
- Page 28 and 29: CG Drives & Automation 01-5927-01r0
- Page 30 and 31: Serial comm. unit address [270] 2 7
- Page 32 and 33: 2 7 3 Setting o F F Serial comm. co
- Page 34 and 35: 7.8 Map 7.8.1 Definitions This is t
- Page 36 and 37: 7.8.3 Response Bit Output from MSF
- Page 38 and 39: Bit Output from MSF Setting Comment
- Page 40: CG Drives & Automation Sweden AB M
10 FieldBus I/O CG Drives & Automation 01-5927-01r0