Emotron Encoder board 2.0 Option
Emotron Encoder board 2.0 Option Emotron Encoder board 2.0 Option
4 Introduction CG Drives & Automation 01-5917-01r0
2. Installation This chapter describes how to mount the option board in the AC drive. Up to three different option boards and one communication board can be mounted. 2.1 Polarisation of flat cables The flat cable is marked with colour on one side and has a tap on the micromatch male contact. This side must be matched to the female micromatch contact on the control board and option board respectively, where a small hole in the board is located. Fig. 1 Polarisation of flat cable ! CAUTION! Incorrect connection might cause damage to both the option and to the control board/external equipment. CG Drives & Automation, 01-5917-01r0 Installation 5
- Page 1 and 2: Emotron Encoder board 2.0 Option In
- Page 3 and 4: Safety Instruction manual Read this
- Page 5 and 6: Contents 1. Introduction ..........
- Page 7: 1. Introduction This board is used
- Page 11 and 12: Mounting 1. Make sure that the powe
- Page 13 and 14: 2. Place the insulating sheet over
- Page 15 and 16: 2.4 Mounting another option board 1
- Page 17 and 18: 3. Connections and functions 3.1 Bo
- Page 19 and 20: 3.2.3 Cable recommendations and shi
- Page 21 and 22: NOTE: Only incremental encoder type
- Page 23 and 24: 3.3.3 Electrical specification enco
- Page 25: CG Drives & Automation Sweden AB M
4 Introduction CG Drives & Automation 01-5917-01r0