Emotron Encoder board 2.0 Option
Emotron Encoder board 2.0 Option
Emotron Encoder board 2.0 Option
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2.3 Mounting the first option <strong>board</strong><br />
The first option <strong>board</strong> is always mounted on the slot marked 1 on the mounting<br />
plate. In this example we assume that no other option <strong>board</strong> is installed.<br />
Delivered with the option <strong>board</strong> kit<br />
• <strong>Option</strong> <strong>board</strong> and four screws.<br />
• 16-pole flat cable for connection between two option <strong>board</strong>s.<br />
• Insulating sheet.<br />
Mounting<br />
1. Connect the 16-pole flat cable to the X5 connector on the control <strong>board</strong><br />
with the cable downwards as in Fig. 4.<br />
NOTE: The polarisation of the flat cable, see section 2.1 on page 5.<br />
Fig. 4<br />
Flat cable connected to the control <strong>board</strong><br />
8 Installation CG Drives & Automation, 01-5917-01r0
Change language