IntelliStripe 350, Desktop Motorized Reader, Technical ... - MagTek

More documents

Recommendations

Info

IntelliStripe 350, Desktop Motorized Reader 6
SECTION 2. INSTALLATION The installation of the IntelliStripe 350 Desktop Motorized Reader consists of placing the unit on a flat surface, plugging the I/O connector into the host serial port, and plugging the Power Supply into the I/O cable and into a wall receptacle. COMPONENTS Components of the unit for installation are shown in Figure 2-1. Power Supply And Cable I/O Cable To IntelliStripe 350 AC Cable 9 Pin Connector To Host AC Cable Upper Cover Lower Cover 3 Prong Connector Screw Slots (4) For Retaining Upper And Lower Covers Ejector Rod Magnetic Stripe Down And To The Right Bottom View Two Of Four Foot Pads LED Figure 2-1. IntelliStripe 350 Components 7
Page 1 and 2: IntelliStripe 350 DESKTOP MOTORIZED
Page 3 and 4: LIMITED WARRANTY MagTek warrants th
Page 5 and 6: TABLE OF CONTENTS SECTION 1. FEATUR
Page 7 and 8: SECTION 1. FEATURES AND SPECIFICATI
Page 9 and 10: Section 1. Features and Specificati
Page 11: Section 1. Features and Specificati
Page 15 and 16: Section 2. Installation The Power S
Page 17 and 18: SECTION 3. OPERATION AND MAINTENANC
Page 19 and 20: Section 3. Operation and Maintenanc

IntelliStripe 350, Desktop Motorized Reader, Technical ... - MagTek

Create successful ePaper yourself

Delete template?

Save as template?