DuraPoly Post - Fypon, Ltd.

DuraPoly Post
Paintable Finish
Fypon ® DuraPoly Posts are constructed from advanced, synthetic materials
and can be painted with latex paint to match your project – adding the flexibility
of custom color to any design. In addition, DuraPoly Posts will never rot or
decay, ensuring long lasting strength and dependability. And to complete your
project, a trim kit is available to provide a finished look.
20"
20”
Product Features:
• Structural Post With Metal Insert
• Precise Colonial Detail
• Trim to Fit Your Project
• Paint to Match Your Project
• Virtually Maintenance Free
• Limited Lifetime Warranty
40½"
41"
DuraPoly Paintable Porch Post
Includes Mounting Plates and Screw Pack
Post Size
Load-Bearing
Capacity*
Weight
Per Piece List Price Part Number
43"
5" x 5" x 8' 8" 2,500 lbs. 35 lbs. $125.19 80500588CL
43"
6" x 6" x 8' 8" 5,000 lbs. 38 lbs. $181.90 80500688CL
DuraPoly Post Trim Kit
Includes Screw Pack
5”
Trim Kit Size List Price Part Number
5" Trim Kit Fits 5" DuraPoly Post $26.75 800500PWTK
6”
6" Trim Kit Fits 6" DuraPoly Post $32.10 800600PWTK
*Load-bearing capacity is dependent on the concentric loading of the post.
Note: Post shell is constructed of paintable rigid PVC, trim pieces are constructed of high-density polyurethane.
DuraPoly Post
Trim Kit
Fypon ® warrants DuraPoly products to be free
from defects in material and workmanship. For
complete warranty details, visit fypon.com.

DuraPoly Post
Installation Instructions
Post Kit Includes: (1) DuraPoly Post (2) Mounting Plates
(8) Screws
POST INSTALLATION
Measure opening to determine post length. Deduct 3 /8” total to accommodate top and bottom mounting plates.
• For use with 36” high railing: Do not trim more than 6” from the bottom of post, trim balance from top.
• For use with 42” high railing: Do not trim the bottom of post, trim only the top.
Trim post. A reciprocating saw is recommended (be sure to wear personal protective equipment). Be sure to
match cut with same pitch as slope of floor.
Install ceiling plate using 4 screws (provided). Using a plumb tool, find and mark the bottom plate position on the
floor. Note: Be sure the location of the mounting plates allows the load on the top of the post to be centered and
evenly distributed. Secure bottom plate with (4) screws when in position. Note: The 8 screws provided will work
for wood or masonry applications. When installing screws into concrete, drill a 3 /16” pilot hole 1 /4” deeper than
the length of the screw.
After installation of plates, use a temporary support to raise soffit approximately 1 /2”. Set post on bottom plate.
Position top of post with top plate. Lower soffit on top of post. There is no need to screw post to plate. IMPOR-
TANT: If using a trim kit, slide onto top and bottom of post before post is installed into mounting plates.
Check post with level and remove temporary support allowing the top bracket to fit down on the top of the post.
Important Notes:
• When installing QuickRail railing to the post, pre-drill holes for bracket screws using a 1 /8” drill bit.
• DuraPoly Post Load Bearing Capacity: 5” = 2,500 lbs.; 6” = 5,000 lbs.
• Uplift: If building codes require uplift connection, contact Fypon or your distributor for recommendations.
INSTALLING WITHOUT MOUNTING PLATES
If flush mounting post without plates is desired, follow instructions above, but DO NOT trim additional 3 /8” for
mounting plates. Pre-drill necessary holes at an angle, secure with countersunk screws and fill with putty. A
Trim Kit (sold separately) is recommended to cover the screws.
Tools Required
Tape
Measure
Reciprocating
Saw
Screwdriver
INSTALLING TRIM KIT (Trim Kits Sold Separately)
Trim Kit Includes: (2) Trim Pieces (Top and Bottom) (4) Screws
Before post is installed, slide one trim piece at the top of the post and one trim piece at the bottom of the post.
Use the screws provided to secure the trim pieces at the top and bottom of the post. Countersink screws and fill
with putty.
There may be some marginal spacing in the trim-to-post fit. Exterior caulk can be used as a filler.
PAINTING INSTRUCTIONS
Make sure all surfaces are clean prior to painting.
Prime DuraPoly Post and Trim Kit pieces with a light coat of exterior latex primer.
Allow primer to dry completely before applying 2 coats of exterior latex paint. (Allow adequate drying time in
between each coat of paint.)
Important Notes:
• Do not use paint or solvents containing acetone.
• Oil based primer and paint are not recommended. Krylon ® Fusion ® paint is an alternative to exterior latex.
• Do not paint using dark colors (dark colors are considered any color that falls within the L values of 56 to
0). L is a measure of the lightness of an object, and ranges from 0 (black) to 100 (white).
Drill
Plumb
Line
Personal Protective
Equipment
TM
800.446.3040 · www.fypon.com
Fypon ® is a registered trademark and It's How You Finish. and DuraPoly Post are trademarks of Fypon, Ltd.
All rights reserved. © 2009 Fypon, Ltd.
FYQR - 4.09