WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Disassembly / Reassembly<br />
4<br />
Pre-combustion chamber, removal<br />
Before proceeding with removing the pre-combustion chamber it is<br />
necessary to remove the pre-heating glow plug.<br />
Screw special tool "7107-1460-030" 1 into the pre-combustion<br />
chamber.<br />
Carefully, but sharply, slide the slide hammer 2 up the special tool<br />
shaft until contact is made with end of the tool. The hammer effect of<br />
the special tool will extract the pre-combustion chamber 3.<br />
76<br />
77<br />
78<br />
79<br />
Pre-combustion chamber, installation<br />
The pre-combustion chamber has a hole on the side where the preheating<br />
glow plug 2 must be inserted.<br />
When re-fitting introduce the the new pre-combustion chamber into<br />
the cylinder head so that the side hole of the pre-combustion<br />
chamber aligns with the glow-plug hole.<br />
To make sure that both the holes align appropriately use tool "7107-<br />
1460-031" 1 inserting it into the glow-plug hole.<br />
Tighten the ring nut twice:<br />
1st tighten at a torque of 100 Nm,<br />
2nd tighten at a torque of 180 Nm.<br />
Chack that clearance A is 3,56÷4,04 mm.<br />
Oil pan, removal<br />
1<br />
Danger - Attention<br />
- The used engine oil can cause skin-cancer if kept frequently<br />
in contact for prolonged periods.<br />
- If contact with oil cannot be avoided, wash carefully your<br />
hands with water and soap as soon as possible.<br />
- Do not disperse the oil in the ambient, as it has a high<br />
pollution power.<br />
Remove the fixing screws 1.<br />
When reassembling, replace the seals 2.<br />
Tighten the screws at a torque of 10 Nm.<br />
2<br />
Before starting the engine make sure that:<br />
1) the oil drain plug is tightened correctly<br />
2) the engine has been refilled with the prescribed quantity of oil (see<br />
page 20).<br />
80<br />
FOCS Workshop Manual_cod. 1.5302.858_1° ed_ rev. 00<br />
- 41 -