WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4<br />
Disassembly / Reassembly<br />
Valve seats and housings -<br />
Dimensions (mm)<br />
mm<br />
A 35,220÷35,245<br />
α<br />
α1<br />
B 35,306÷35,315<br />
C 31,220÷31,241<br />
44°<br />
53' ÷ 45° 59° 53' ÷ 60°<br />
D 31,308÷31,316<br />
Press valve seats into the housings<br />
70<br />
Note: Valve seatsare supplied in finished form, further machining is<br />
prohibited.<br />
Valve recess and seat sealing width<br />
Dimensions (mm):<br />
mm<br />
Limit value<br />
D 0,7÷1,<br />
0<br />
1, 3<br />
S 1,<br />
6<br />
2, 0<br />
71<br />
72<br />
Grind valve seats with fine emery paste.<br />
After grinding check the valve recess D relative to the cylinder head<br />
surface and the seat sealing width S.<br />
PRE-COMBUSTION CHAMBER<br />
Components:<br />
1 Pre-combustion chamber<br />
2 Pre-heating glow plug<br />
3 Pre-combustion chamber ring nut<br />
4 Cylinder head<br />
The pre-combustion chamber does not normally require removal or<br />
<strong>service</strong>, if <strong>service</strong> is necessary follow the procedure described below.<br />
73<br />
Pre-combustion chamber ring nut removal<br />
The pre-combustion chamber is fixed to the cylinder head by a ring<br />
nut, so before removing the pre-combustion chamber it is necessary<br />
to unscrew the pre-combustion chamber ring nut.<br />
Use the special tool "7107-1460-027" 1 to romve the ring nut 2.<br />
74 75<br />
- 40 - FOCS Workshop Manual_cod. 1.5302.858_1° ed_ rev. 00