WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Disassembly / Reassembly<br />
4<br />
Intake, exhaust, injection camshaft lobe height<br />
A1 = 1st cylinder intake camshaft lobe<br />
A2 = 2nd cylinder intake camshaft lobe<br />
A3 = 3rd cylinder intake camshaft lobe<br />
I1 = 1st cylinder injection camshaft lobe<br />
I2 = 2nd cylinder injection camshaft lobe<br />
I3 = 3rd cylinder injection camshaft lobe<br />
S1 = 1st cylinder exhaust camshaft lobe<br />
S2 = 1st cylinder exhaust camshaft lobe<br />
S3 = 1st cylinder exhaust camshaft lobe<br />
60<br />
H = 29,598÷29,650 mm (intake/exhaust camshaft lobe height)<br />
H1 = 28,948÷29,000 mm (injection camshaft lobe height)<br />
If wears on the cams exceeds by 0.1 mm the minimum value given<br />
H and H1, replace the crankshaft.<br />
Cylinder head, removal<br />
Important<br />
Do not remove the cylinder head when hot to avoid<br />
deformation.<br />
lf cylinder head is deformed by more than 0.10 mm, level it off by<br />
removing a maximum of 0.20 mm.<br />
For the cylinder head tightening procedure see page 45.<br />
61<br />
FOCS Workshop Manual_cod. 1.5302.858_1° ed_ rev. 00<br />
- 37 -