WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
WORKSHOP MANUAL - lombardini service
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4<br />
Disassembly / Reassembly<br />
54<br />
55<br />
CAMSHAFT<br />
Camshaft, disassembly<br />
Loosen the screws and remove the cover 1.<br />
Check gasket ring 2 for integrity.<br />
Remove the drive rod from the fuel pump.<br />
Gently remove the camshaft, slight rotations may be required to<br />
avoid binding the camshaft lobes against the camshaft bearing<br />
surface bores.<br />
Note: The lift pump drive eccentric 3 is included on the flywheel end<br />
of the camshaft and fixed with a screw.<br />
In case of replacement tighten the eccentric screw at a torque of 80<br />
Nm.<br />
Camshaft, journal and housing measurement<br />
Use an inside micrometer gauge for housing diameters and an outside<br />
micrometer gauge for journal diameters.<br />
56<br />
57<br />
Camshaft journals and housings - Dimensions (mm)<br />
A B A-B<br />
A-B<br />
limit value<br />
37,035<br />
÷ 37,060 36,975<br />
÷ 37,000<br />
0,035<br />
÷ 0,085<br />
0,170<br />
58<br />
Camshaft lobe measurement<br />
Use an outside micrometer gauge.<br />
59<br />
- 36 - FOCS Workshop Manual_cod. 1.5302.858_1° ed_ rev. 00