Operating manual 27.09.2011 CC Heating Thermostats - HUBER

USB Device
The operating mode of the USB device is basically the same as for the Ethernet (see
description on Ethernet interface).
Only the URL/IP address differs from the one used for Ethernet. To connect several
Web.G@tes onto one PC it is necessary to be able to allocate multiple ports to those
different Web.G@tes. This is done via the controller (Web.G@te -> USB Port). Please
note, that the URL will change then, e.g usb3.webgate.net instead of usb1.webgate
.net.
USB Host
This is a standard interface for USB sticks and HDDs to e.g save temperature control
programs. Ext2 and Fat32 are supported as file systems.
How to save temperature control programs:
Save program:
Enter program → e.g. program 1 → Web.G@te → Save program. Program is saved
under the name that appears in the controller.
Load program:
Enter program → e.g. program 1 → Web.G@te → Load program. A list is shown with
all programs saved on the stick. Choose program. Program is loaded.
Temperature programs saved on the stick can also be edited on the PC via TPXplorer.
Password for Webpage
The password for the webpage of the thermostat can be set and changed on the
controller (Web.G@te -> Password Webpage).
Bluetooth Stick
Support for Blue!Fritz Bluetooth Stick: Communication and control of the machine via
mobile phone.
Operation with mobile phones that support: CLDC1.1 MIDP2.0/CDC PBP/SE
The software for the operation via mobile phone can be downloaded form the
Web.G@te if the mobile phone supports the above standard. Please note, that the
following procedure is different for any mobile phone:
Pairing with Web.G@te: search for Bluetooth devices. A name appears like
Web.G@teXXX. Avtivate Pairing. Enter code: „1234“. Confirm the contact on the
controller. The machine can be controlled via Bloetooth.
77