Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Operating manual 27.09.2011 CC Heating Thermostats - HUBER
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The following interfaces are available:<br />
1. RS232/SERIAL (Standard Interface! Included in all <strong>CC</strong> units with <strong>CC</strong>-Pilot)<br />
2. Com.G@te internal or external version depending on the unit (Extension of an<br />
analogue interface or a further digital interface)<br />
3. Web.G@te internal or external version depending on the unit (Control possible<br />
via Intranet, Internet, USB…)<br />
Caution!<br />
With plug-in connections subject to a higher voltage than 60 V (AC) and 40 V (DC)<br />
there is the risk of receiving an electric shock or of damaging the interface module. Only<br />
components requiring voltages of less than 60 V (AC) and 40 V (DC) should be<br />
connected, in order to ensure the safety of the interface module.<br />
RS232/SERIAL<br />
Wiring RS232:<br />
Pin2 RxD Receive Data<br />
Pin3 TxD Transmit Data<br />
Pin5 GND Signal GND<br />
The Baudrate is set to 9600. It cannot be changed! An operation via the interface<br />
RS232/SERIAL is not possible if the temperature control unit is controlled via remote<br />
control by the <strong>CC</strong>-Pilot.<br />
5<br />
9<br />
6<br />
1<br />
71