Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
F30 Set date<br />
Setting the date.<br />
F31 Set time<br />
Setting the time.<br />
F33 Set over-temperature protection<br />
Setting the over-temperature protection. Please note chapter on setting the overtemperature<br />
switch.<br />
F34 Air purge<br />
Start / Stop air purge<br />
F35 Compressor automatic<br />
This is used to select the operation of the compressor: Default setting is always ON<br />
Automatic:<br />
The compressor automatic is set to switch on and off as required by the unit.<br />
Benefit: Energy saving<br />
Disadvantage: Longer response times to sudden increase in cooling demand.<br />
Always ON:<br />
The compressor is always running, so the refrigeration system is always immediately<br />
available.<br />
Always OFF:<br />
The compressor is always off.<br />
The compressor automatic (valid for units with compressors only) must be set to<br />
always on when selecting process security in the main menu<br />
Over-temperature protection / OT Mode<br />
F37 Temperature mode<br />
Setting the temperature mode.<br />
F39 Signal<br />
Activating the signal.<br />
F40 Test RS232<br />
Start / Stop<br />
F41 Select user menu<br />
Please refer to chapter select user menu.<br />
F42 Configure user menu<br />
Please refer to chapter configure user menu.<br />
F46 Define analogue input (function analogue input)<br />
This function allows an analogue input current of 0/4-20 mA or 0-10V to be assigned<br />
to an input value.<br />
51