Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Operating manual 27.09.2011 CC Heating Thermostats - HUBER
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Over-temperature protection<br />
Cut-off limits can be set in the heating chamber / heating. Please note chapter on<br />
setting the Overtemperature protection (OT).<br />
Program Start & stop<br />
Corresponds to function F23 in the Funct. No. menu. Here you can start, interrupt or<br />
end a program. If the temperature control machine has a Com.G@te connected,<br />
then the graphics display (60) will give a notice concerning the POCO/Alarm, as well as<br />
the analogue interface at program start. Please also note the sections on POCO/Alarm<br />
and on the analogue interface.<br />
Pump settings<br />
Settings and status information on pump.<br />
Set-point<br />
This corresponds to Function F0 in the Funct. no. menu.<br />
The set-point is limited to the band between the upper and lower set-point limits.<br />
The following is true:<br />
minimum set-point