Operating manual 27.09.2011 CC Heating Thermostats - HUBER

Comfort menu
Here one can switch to the whole range of functions.
Please also note the chapter on Comfort menu, where further functions of the comfort
menu are described.
Display modes
Following functions are available:
30
1. Standard: Values are displayed numerically (valid for all temperature control
devices with Unistat Pilot and CC-Pilot).
2. Graphic: Internal temperature, process temperature and set-point are displayed
graphically – valid for Unistat Pilot. (with CC-Pilot only possible with Exclusive or
Professional upgrade package).
3. Device message: please see following example (valid for all temperature control
devices with Unistat Pilot and CC-Pilot).
4. Status Interfaces: Information on switch condition of e.g. ECS and POCO /
ALARM (valid for all temperature control devices with Unistat Pilot and CC-Pilot).
5. Large display: Values are displayed in large numerical format (valid for all
temperature control devices with Unistat Pilot and CC-Pilot).
6. Summary 1: Service information (valid for all temperature control devices with
Unistat Pilot and CC-Pilot).
7. Return to main menu
Display modes is used to select the required display or information window (e.g. Status
Interfaces or Device message). The standard setting is Graphic.
Example: Display on choosing Device message.
Date / Time of the
Message
Message in clear text
Status information in
clear text.
Status information in
clear text.
10.04.06 3/100
17:11:39
Message-ID: -16427
Actual status: 0x000F
Pump running
compressor stopped
Heating on
Manual set-point active
2nd set-point not active
Mains frequency. 50Hz detected
230V AC 1 Phase
Extended Status: 0x000D
Compressor on
Fan on
Power isolation relays activated
Message - counter
Message - number
Info: present Status
Info: extended Status
By turning the rotary knob / key (61) one can display the individual messages. Take
note of the message counter for reference.