MACH 130 FP Mains Voltage 230V / 120V - Dr. Mach

MACH 130 FP Wall model
6. Maintenance
Dr. Mach
Lamps and Engineering
The lamp has been designed and built so that regular maintenance intervals are not necessary.
In order to keep the system easy running throughout its life span we recommend that the hinges be
greased once a year with an acid-free grease.
The lamp body may only be dismantled from the spring arm in reverse order to its assembly after the assembly
locking device has been inserted and tightened since the arm is under spring tension.
Attention: Screw the transport safeguard into place in the spring arm before removing the lights.
F
F
6.1 Adjustments at the wall attachment
♦ Adjusting the spring force
The spring arm is correctly adjusted when the light
remains in position at every set height and can be
moved more easily upwards than downwards.
Should you discover that the light no longer remains
at its set height, proceed as follows:
• Turn off the lamp.
• Push the two circular areas F on the sides carefully
apart. Remove the cover from the front.
• Move the spring arm into a position in which the
hole nut is visible.
Attention: If the max. height of the spring arm is
limited, the hole nut may in certain circumstances
remain invisible. In this case consult
your dealer or Dr. Mach directly.
• Place the key bolt that can be found below the
cover on the top of the spring arm in the hole
and turn accordingly. Use only the enclosed key
bolt since a screwdriver could break.
Proceed as follows depending on the movement of
the light.
a. Lamp moves down on its own - turn bolt in the
direction of the „+“ mark.
b. Lamp moves up on its own - turn bolt in the direction
of the „−“ mark.
59100002 Edition 07 05.06.2002 / Bak Page 12/25