AirStar Installation Manual - MacroAir HVLS Fans

More documents

Recommendations

Info

TOOLS REQUIRED 3. 1. Socket set and ractchet (deep and short wall) 2. 3/8 allen key 4. 3. Magnetic level 4. Phillips and Flat Head Screw driver 2. 5. Network crimping tool (if standard connection will not work.) 1. 5. 6. Torque Wrench (Not Shown) 6 Copyright MacroAir 2013 macroairfans.com AirStar Installation Manual
FAN CLEARANCE & PLACEMENT Slope (in) 2/12 4/12 6/12 8/12 10/12 Roof Angle 9.5 o 18.4 o 26.6 o 33.7 o 39.8 o Diameter Recommended Extension Length Clearance Radius 8 feet N/A N/A 1 1 2 15’’ 10 feet N/A 1 1 2 3 18’’ 12 feet N/A 1 2 3 4 22’’ The goal of this diagram is to determine the proper extension length to maintain a minimum blade clearance of 15% of the fan’s diameter. The extension lengths above are minimum recommendations only, based solely on roof pitch and fan diameter. Other factors must be evaluated when determining extension requirements. In addition, OSHA requirements state that the fan blades must be a minimum of 10 feet (3.05 meters) above the floor. Contact our technical department for assistance with fan placement and extension selection (technical support contact information can be found on page 39). 7 Copyright MacroAir 2013 macroairfans.com AirStar Installation Manual
Page 1 and 2: 1 Copyright MacroAir 2013 macroairf
Page 3 and 4: TABLE OF CONTENTS Page 4 - Caution
Page 5: PACKAGE CONTENTS Power Unit Remote
Page 9 and 10: GLULAM MOUNT Installation on Glulam
Page 11 and 12: EXTENSION ASSEMBLY When Extension i
Page 13 and 14: BLADE RETAINER INSTALLATION This im
Page 15 and 16: TECHNICAL SUPPORT For installation

AirStar Installation Manual - MacroAir HVLS Fans

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?