You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 12<br />
FOLD PLATES<br />
SERVICE<br />
Stop<br />
Screws -<br />
Upper Rail<br />
=<br />
=<br />
Deflector Fingers<br />
Handwheel<br />
Grub Screw -<br />
Timing Pulley<br />
Tilt Control - Set to Zero<br />
Timing Pulley - Drive Side<br />
Fold Plate Deflector Alignment ..................................Fig 12.12<br />
12.3 .....Fold Plate - Deflector<br />
When the operator sets the tilt adjustment, (on the fold plate<br />
handwheel) to zero, the deflector should be perfectly parallel to the<br />
front rail and this can be checked by winding the deflector towards<br />
the upper rail and comparing the position of the deflector fingers<br />
with the rail.<br />
They must line up exactly and if they do not, the deflector can be<br />
adjusted by releasing the grub screws on the drive side pulley,<br />
(which is mounted on a sleeve to facilitate small adjustments) and<br />
rotating it slightly on it’s shaft until it is set correctly.<br />
PAGE 32<br />
FOLDING