You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 8<br />
OUTER FOLD ROLLERS<br />
SERVICE<br />
Spring<br />
Max. Lateral Movement = 0.025mm<br />
Spring Pad<br />
Adjusting Screw & Locknut -<br />
Spring Pressure<br />
Adjusting Screw &<br />
Locknut - Roller Pressure<br />
Calliper Pad<br />
Moving Calliper<br />
Clamp Screws<br />
Linear Bearings<br />
Linear Bearing - RH<br />
Linear Bearing - LH<br />
Calliper Jaw<br />
Bearing Plate<br />
Max. Lateral Movement = 0.025mm<br />
Linear Bearings .......................................................... Fig 8.21<br />
8.2 .......Linear bearings - Continued<br />
Each moving calliper has two linear bearings which should be set<br />
one at a time. as follows:-<br />
1. The right-hand linear bearing should be positioned clear of<br />
the moving calliper and both screws tightened.<br />
2. Push the left-hand linear bearing against the bearing plate<br />
(as indicated) and lightly tighten both screws.<br />
3. Check for lateral movement at both the top & bottom of the<br />
moving calliper and if it is excessive go to step 4. If there is<br />
no lateral movement go to step 5<br />
PAGE 20<br />
FOLDING