Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MANUAL FEED DRIVE BELT Section 6<br />
M4 Fixing Screws<br />
- Belt Cover<br />
Motor Mounting<br />
Bracket<br />
M5 Nuts (& Bolts)<br />
- Motor Bracket<br />
Drive Motor<br />
Feed Bed<br />
Gas Strut<br />
Drive Pulley<br />
- Motor<br />
Drive Belt<br />
- Toothed<br />
Torque Disc<br />
Gear-Box<br />
Belt Cover<br />
Feed Drive Belt ........................................................... Fig 6.11<br />
6.1 .......Feed Drive Belt - Access<br />
The feed drive belt (which takes the drive from the motor to the<br />
gearbox) is accessed by removing the six screws securing the belt<br />
cover and sliding the cover over the pulleys.<br />
The feed drive belt must be correctly tensioned as insufficient or<br />
excessive tension will cause vibration.<br />
Slacken the four nuts securing the motor bracket to the feed bed.<br />
Adjust the bracket as required to obtain the correct tension.<br />
When correctly tensioned the belt will deflect approximately 5mm<br />
(3/16”) when a force of 1.2Kg ( 2.6lb) is applied to the mid point of<br />
it’s run between the pulley’s.<br />
Note ........ Take care to keep the motor parallel to the gearbox.<br />
SYSTEMS PAGE 15