UFO Service V2 Mar02 625-030.pdf

MANUAL SIDE - LAY
Section 4
3.2 .......Vacuum Roller - Adjustment
The grub screw should initially be lightly tightened opposite the
suction choke. (see fig. 3.11)
However, with the vacuum roller assembly fitted to the machine,
the grub screw should be fully tightened so that the suction choke
is in it's normal operating position (at the top) with the adjusting
knob accessible, and without the vacuum hose trying to rotate the
suction choke out of position.
4.1 .......Side-Lay - Removal
The side-lay is removed as follows:-
Remove all the paper transport balls from their holders.
Move the side-lay to the third position from the outside and tighten
the screws.
Raise the feed bed, disconnect the gas strut from the side frame,
raise the feed bed further, and support the strut on the conveyor
roller.
Remove the two fixing screws (see fig.5.21 ), which secure each of
the two roller retainer brackets.
Lower the feed bed and release the two locating knobs on the top
of the side-lay.
The side-lay can now be lifted off the feed bed.
With the side-lay indicators set to zero (‘0’), the gap between the
floating and fixed side-lays should be 10mm and the stop screws
should have the underside of their heads set 5mm from the face of
the floating side-lay.
SYSTEMS PAGE 11