Owner's Guide to Installation and Use - Stark Electronics
Owner's Guide to Installation and Use - Stark Electronics
Owner's Guide to Installation and Use - Stark Electronics
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
*<br />
Adjust rota<strong>to</strong>r<br />
for free turn<br />
thru full circle<br />
Loop<br />
<strong>to</strong> allow<br />
full turn<br />
of antenna<br />
*<br />
Antenna<br />
Antenna Mast<br />
Drive Unit<br />
Loop<br />
<strong>to</strong> allow<br />
full turn<br />
of antenna<br />
Amplifier<br />
<strong>Use</strong> 1¹⁄₄" mast<br />
for true rotation<br />
Antenna Cable<br />
Support Mast<br />
3 or 4 wire<br />
rota<strong>to</strong>r cable<br />
Coaxial Cable<br />
St<strong>and</strong>ard Mast Mounting<br />
*<br />
Mount antenna as close <strong>to</strong> ro<strong>to</strong>r as<br />
possible. <strong>Use</strong> no more than 3 feet<br />
of mast in <strong>to</strong>p of drive unit.<br />
Electrical Tape<br />
Tower Mounting<br />
Do not mount citizens b<strong>and</strong> base station antennas on <strong>to</strong>p of a st<strong>and</strong>ard mast mount drive unit.<br />
Mast support may become overloaded in high winds.<br />
STEP 3 – Connect rota<strong>to</strong>r cable <strong>to</strong> drive unit terminal board following the sketch at the right.<br />
Caution: When using jacketed cable, be sure jacket of cable passes thru the grommet <strong>to</strong> avoid<br />
moisture collecting in the cable.<br />
Terminal Connections<br />
Red Wire<br />
<strong>to</strong> #3<br />
Black Wire<br />
<strong>to</strong> #2<br />
Drive Unit<br />
Green Wire <strong>to</strong> #1<br />
Grommet<br />
Cover<br />
Grommet<br />
Terminals<br />
Caution – Make sure bare connec<strong>to</strong>rs do not <strong>to</strong>uch. It is suggested that the screws <strong>and</strong> bare<br />
conduc<strong>to</strong>rs be painted with nail polish after cable is connected. To avoid moisture collecting<br />
in the cable be sure jacket of cable passes thru the grommet.<br />
STEP 4 – Attach rota<strong>to</strong>r cable <strong>and</strong> antenna cable securely <strong>to</strong> mast or <strong>to</strong>wer, <strong>and</strong> pass through<br />
building <strong>to</strong> TV or FM set.<br />
Note: See Step 2 of the Important Safeguards section regarding grounding of the control cable <strong>and</strong><br />
lead-in cable for lightning protection.<br />
2