DS335 Synthesized Function Generator

DS335 Setup 2-17
INSTRUMENT SETUP
Introduction
This section describes the DS335's default settings, storing and recalling
settings, setting the computer interfaces, and running self-test.
Default Settings
Press [SHIFT][+/-] to recall the DS335's default settings. The DS335's default
settings are listed below:
Setting
Frequency
Function
SYNC ON/OFF
Load Impedance
Display
Amplitude
Offset
Inversion
Sweeps
Start Frequency
Stop Frequency
Trigger Source
Sweep/FSK Rate
Default Value
1 MHz
Sine
On
50Ω
Frequency
1 Vpp
0.0 V
Off
Off
1Hz
3.1MHz
Continuous
100 Hz
Interface
RS232
Baud Rate 9600
GPIB Address 22
Storing Setups
Recalling Stored Settings
GPIB Setup
To store the DS335's current setup press [SHIFT][7] followed by a location
number in the range 0 - 9. After pressing any UNITS key to enter the
location number, the message "sto done" will be displayed, indicating that the
settings have been stored.
To recall a stored setting press [SHIFT][8] followed by a location number in
the range 0 - 9. After pressing any UNITS key to enter the location number
the message "rcl done" will be displayed, indicating that the settings have
been recalled. If nothing is stored in the selected location, or the settings are
corrupted, the message "rcl err" will be displayed.
To set the DS335's GPIB interface press [SHIFT][1]. The GPIB enable
selection will be displayed. Use the [UP ARROW] and [DOWN ARROW]
keys to enable the GPIB interface. Press [SHIFT][1] again to display the
GPIB address. Enter the address desired using the numeric keypad or arrow
keys. The range of valid addresses is 0 - 30.
NOTE: If the DS335 does not have the optional GPIB/RS232 interfaces the
message "no GPIB" will be displayed when the GPIB menu is accessed.
Only one of the GPIB and RS232 interfaces may be active at a given time,
the RS232 interface is automatically disabled when GPIB is enabled.
DS335 Synthesized Function Generator