DS335 Synthesized Function Generator
DS335 Synthesized Function Generator
DS335 Synthesized Function Generator
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Function</strong> Setting 2-11<br />
Vpp<br />
Vrms<br />
<strong>Function</strong> Max. Min. Max. Min.<br />
Sine 20V 0.1V 7.07V 0.04Vrms<br />
Square 20V 0.1V 10.0V 0.05Vrms<br />
Triangle 20V 0.1V 5.77V 0.03Vrms<br />
Ramp 20V 0.1V 5.77V 0.03Vrms<br />
Noise 20V 0.1V 3.24V 0.02Vrms<br />
HIGH-Z Load Impedance<br />
Output Inversion<br />
D.C. Only<br />
DC OFFSET<br />
SYNC ENABLE<br />
The <strong>DS335</strong>'s output may be inverted for ramp functions. This is useful for<br />
turning positive ramps into negative ramps. Entering a negative amplitude<br />
inverts the ramp output.<br />
The output of the <strong>DS335</strong> may be set to a DC level by entering an amplitude<br />
of 0 V. When the amplitude is set to zero the A.C. waveform will be<br />
completely shut off and the <strong>DS335</strong> may be used as a DC voltage source.<br />
When the [OFFS] key is pressed the DC offset is displayed and the V pp<br />
indicator LED will be lit. A new value may be entered numerically with any<br />
amplitude unit key. In general, the DC offset may range between ±5V, but is<br />
restricted such that |V ac peak | + |V dc | ≤ 5 V (into 50 Ohms), or | V ac peak | +<br />
|V dc | ≤ 10 V (into HIGH-Z). The DC offset is also restricted such that |V dc | ≤<br />
2 x V pp . When the offset is changed, the output signal will briefly go to zero<br />
as the output attenuators are switched, and then back to the set offset value.<br />
Pressing the [SHIFT] [.] key enables the SYNC OUT function. The<br />
[SHIFT][0] disables the output by highly attenuating the output function<br />
signal.<br />
<strong>DS335</strong> <strong>Synthesized</strong> <strong>Function</strong> <strong>Generator</strong>
Change language