SPECIALTY AUTOMOTIVE TOOLS

ENGINE
H3099
H3099 Y
FROST PLUG INSTALLER KIT
• Eliminates the necessity of removing heads and manifolds
or cutting through the firewall to install frost plugs in most applications
• 18" handle with swivel collar
Kit includes:
H3099A Adaptor 3/4"
H3099B Adaptor 1"
H3099C Adaptor 1-1/4"
H3099D Adaptor 1-1/2"
H3099E Adaptor 1-3/4"
H1483
H1483
UPPER REAR MAIN SEAL KIT
• This handy kit eliminates the need to remove engine or crankshaft when replacing either wick
or neoprene upper rear main bearing oil seals
• Comes complete with extractor for worn seals, stainless steel “Chinese Fingers” seal installer,
two sizes of compressing guide funnels, packing punch, trimming knife, curve chaser die and
self-aligning flat steel chaser
H1139 L
CAM-WEDGE TYPE STUD REMOVER
• A compact and powerful tool that can fit into hard-to-reach places to loosen
or tighten hard-to-turn studs
• The cam-wedge knurled roller assembly grips like a pipe wrench with added torque
• Made from high grade heat treated alloy steel. Zinc plated
Range: 1/4" to 3/4" (6 to 19mm) diameter x 1/2" Sq. DR
H1139
CAUTION: Do not use with air or electric tools.
Replacement Part:
H1139B Knurled Roller Assembly
Gripper roller assembly is designed to wear and is excluded from the warranty program
H1585
H1585
RIDGE REAMERS
• This extra-sturdy, extra-durable ridge reamer will handle all modern engines with bores
including canted and most short stroke types
• Tool sits solidly in the cylinder, with holding blades maintaining good wall contact for smooth
cut. Cutter head guide plate locks on both sides
• Tungsten carbide Saf-T-Blade will not overcut, chatter or dig in
• Smooth cutting action of this ridge reamer is attained by fine-thread feed-up
• Accuracy is maintained by heavy, heat-treated center bolt
• Steel collar on center bolt protects threads from wrench damage
• Three position setting of spring-loaded cutter head permits change from one cylinder to
another without adjusting cutter head assembly
• Range 3" - 5"
H1591 Replacement Carbide Cutter — for H1585
H1261
H1261
RIDGE REAMERS
• Sturdy, dependable, accurate. Cutting blade follows cylinder wall under spring tension regardless
of the shape of the bore
• Smooth cutting action is attained by manual thread feed-up
• Saf-T-Blade prevents over-cutting metal after the ridge is removed
• Range 2" - 3"
Replacement Cutter — for H1261 Ridge Reamers
H1059 Carbon Steel Saf-T-Blade
26
ENGINE
www.jetequipment.com