SJ700-2 Instruction Manual NT204DX - Hitachi America, Ltd.

Chapter 3 Operation
Key operation and transition of the
codes on display
Key operation and transition of the monitored data on display
Pressing the 1 or 2 key respectively scrolls up or down the code displayed in code display mode or
increases or decreases the numerical data displayed in data display mode.
Press the 1 or 2 key until the desired code or numerical data is shown. To scroll codes or
increase/decrease numerical data faster, press and hold the key.
Monitor mode
Pressing the
FUNC
key with a function code displayed shows the
monitored data corresponding to the function code.
FUNC
FUNC
(Monitor display) (*1)
or STR
FUNC
Pressing the
STR
or key with the monitored data displayed reverts
to the display of the function code corresponding to the monitored data.
* With the factory setting, the monitor shows initially after
power-on.
Pressing the
FUNC
key in this status changes the display to .
Function or extended function mode
Pressing the FUNC key with a function code displayed shows the data
corresponding to the function code.
(Data display) (*1)(*2)
Up to the
maximum limit Data setting
Pressing the 1 or 2 key respectively increases or
decreases the displayed numerical data.
(Press the key until the desired data is shown.)
FUNC
FUNC
or
STR
STR
Pressing the key with numerical data displayed
stores the data and then returns to the display of the
corresponding function code.
Note that pressing the FUNC key with numerical data
displayed returns to the display of the function code
corresponding to the numerical data without updating
the data, even if it has been changed on display.
Down to the
minimum limit
*1 The content of the display varies depending on the
parameter type.
*2 To update numerical data, be sure to press the
STR key after changing the data.
3 - 6