SJ700-2 Instruction Manual NT204DX - Hitachi America, Ltd.

Chapter 7 Specifications
(3) Common specifications of 200 V class and 400 V class models (continued)
Model name (type name)
SJ700-XXXFF2.FEF2,FUF2
Operating
environment
Optional boards
Ambient
temperature,
storage
temperature(note5),
humidity
Vibration tolerance
(See Note 1.)
Installation
environment
Coating color
Feedback option
Digital input option
DeviceNet option
LonWorks option
Profibus-DP option
Other optional components
004
L
007
L/H
015
L/H
022
L/H
037
(040)
L/H
055
L/H
075
L/H
110
L/H
150
L/H
-10°C to +50°C (ambient), -20°C to +65°C (storage), 20% to 90% RH (no condensation allowed)
5.9m/s 2 (0.6G),10~55Hz
185
L/H
220
L/H
300
L/H
370
L/H
450
L/H
Environment without corrosive gases and dust, at an altitude of 1,000 m or less
Gray
Vector control with sensor
4-digit BCD input, 16-bit binary input
Option to support the open-network DeviceNet function
Option to support the open-network LonWorks function
Option to support the open-network Profibus-DP function
550
L/H
750
H
900
H
2.94m/s 2 (0.3G),10~55Hz
Braking resistor, AC reactor, DC reactor, noise filter, operator cables, Harmonic-wave suppressor unit,
LCR filter, analog operation panel, regenerative braking unit, controllers for various applications
Note 1: The vibration tolerance was tested in compliance with JIS C0040 (1999).
Note 2: The insulation distance complies with the UL and CE standards.
Note3: The applicable motor refers to Hitachi standard 3-phase motor(4-pole).when using other motors,care must be taken to prevent
the rated motor current(50/60Hz)from exceeding the rated output current of the inverter.
Note4:Function “64(EMR)”cannot be assigned to input terminal 3 by an operation from the operator. The function is automatically
assigned to the terminal when slide switch SW1 is set to ON.
Note5:The storage temperature refers to the short-term temperature during transport.
Note6:The frequency command will equal the maximum frequency at 9.8V for input voltage 0 to 10VDC,or at 19.8mA for input current
4 to 20mA.If this characteristic is not satisfactory for your application, contact your Hitachi sales representative.
1100
H
1320
(1500)
H
7 - 3