Table of Contents - The Atmospheric Studies Group at TRC

Section 9: CALPUFF
Table 9-3 (Continued)
CALPUFF Control File Inputs - Input Group 0
Input and Output File Names
and provide all of the CALMET file names in Input Group 0a:
-------------
Subgroup (0a)
-------------
The following CALMET.DAT filenames are processed in sequence if NMETDAT>1
Default Name Type
File Name
------------ ---- ---------
none input ! METDAT= CALMET1.DAT ! !END!
none input ! METDAT= CALMET2.DAT ! !END!
none input ! METDAT= CALMET3.DAT ! !END!
Note that each filename entered in Input Group 0a is treated as a separate input subgroup and therefore
must end with the input group terminator (!END!). A total of NMETDAT lines assigning the CALMET
file names must be present, and the names must be ordered in the proper sequence (e.g., CALMET results
for June must not precede CALMET results for February).
For the emissions files, you may either place a single file name in the main section of Group 0, and place
no names in the corresponding subsection, or you may place all names in the subsection (any names
placed in the subsection replace any name specified in the main Group). Using the point source variable
emissions file as an example, if you have 1 file you may either set the name in the main group:
INPUT GROUP: 0 -- Input and Output File Names
--------------
Default Name Type
File Name
------------ ---- ---------
PTEMARB.DAT input ! PTDAT = pts1.dat !
Provision for multiple input files
----------------------------------
Number of PTEMARB.DAT files for run (NPTDAT)
Default: 0 ! NPTDAT = 0 !
-------------
Subgroup (0b)
-------------
The following PTEMARB.DAT filenames are processed if NPTDAT>0
(Any PTEMARB.DAT name provided above is replaced)
Default Name Type
File Name
------------ ---- ---------
none input * PTDAT = * *END*
9-51