Appendix

13.2 Function Code List
13.2.1 Function Code List Description
Item Description
Fcode Identification codes for function codes.
Communication Address used with integrated RS-485 or UPAC option (OPC-VG7-UPAC) to refer to or
address
485 number
change function codes.
Communication Address used with field bus options (OPC-VG7-TL, OPC-VG7-SX and field bus options)
address
to refer to or change function codes. You cannot use a filed bus option for a function
Link number code without a communication address Link number.
Function code
name
Function directory
name
Name assigned to a group of function codes with a similar nature.
Name of an individual function of a function code.
Setting range Indicates the setting range and the data definition.
Factory setting Data specified by FUJI before delivery. Modified data are displayed with ∗ (asterisk) on
the KEYPAD panel. You can use the initialization function code to reset them to the
factory setting.
Type
Indicates a format type used to refer to or change data through communication system
(such as RS-485 and filed bus).
See 13.3 “Function Code List Dedicated for Communication” for more information.
Copy
Save all
Initialization
Control type:
Available/ Not
available
Lifting machine
13.2.2 List
F: Fundamental Functions
Indicates whether to be copied or not to another inverter when you use the copy function
of the KEYPAD panel to copy entire data stored in the KEYPAD panel.
Indicates the function code saved with H02 “save all function” (writing the non-volatile
memory). �: Saved function. ×: Function not saved.
Indicates whether to be initialized (reset to the factory setting) or not by the function code
H03 “Data initializing”. �: Initialized, ×: Not initialized.
Indicates whether available or not in individual control types (PG: Vector control with PG,
LES: Sensorless vector control, VF: V/f control, SM: Vector control to drive synchronous
motor).
Indicates the parameter displayed on the keypad panel if H70 is set at “1 (lifting
machine).” �: displayed, ×: Not displayed
Communication
Control type: Available/
address
Fcode
485 Link
number number
Function code
name
Function directory name
Setting range
Not available
PG LES VF SM
f00 0h 50 h Data protection 0 to 1 “*” is displayed on the keypad panel.
0 : Data change enable
1 : Data protection
This is a function to protect writing from the Keypad
panel.
The protection of writing from the link (T-Link,
RS485, etc.) is defined with H29 "Link function
protection".
40 x o o o o o o o
f01 1h Speed setting N1 0 to 7
0 : KEYPAD operation ( ∧ and ∨ key)
1 : Analog input (0 to ±10VDC)
2 : Analog input (0 to +10VDC)
3 : UP/DOWN control 1 (initial speed = 0 r/min)
4 : UP/DOWN control 2 (initial speed = last value)
5 : UP/DOWN control 3 (initial speed = Creep
speed 1 or 2)
6 : DIA card input
7 : DIB card input
You can change the setting of a function indicated by during operation.
You should stop operation to change the setting of other functions.
13-2
Type
Copy
Save all
Initialization
Lifting
machine
41 o o o o o o o o
Underline indicates a factory setting.