SOLDIER'S MANUAL AND TRAINER'S GUIDE MOS 250N ... - AskTOP
SOLDIER'S MANUAL AND TRAINER'S GUIDE MOS 250N ... - AskTOP
SOLDIER'S MANUAL AND TRAINER'S GUIDE MOS 250N ... - AskTOP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
STP 11-<strong>250N</strong>-SM-TG<br />
Plan a Message Switch Network at a Signal Battalion<br />
113-324-7001<br />
Conditions: You are in a Signal Battalion S3 environment and must design a message switch network<br />
(EAC, ECB, and Joint). You are given an OPORD, the subscriber requirements, appropriate references,<br />
and status of switching equipment.<br />
Standards: Accepted the plan for inclusion in the OPORD and the plan supported the communications<br />
requirements.<br />
Performance Steps<br />
1. Determine availability of resources.<br />
2. Coordinate higher and adjacent system interface connectivity.<br />
3. Determine switching equipment interface and connectivity requirements.<br />
4. Determine subscriber terminal interface and connectivity requirements.<br />
5. Determine network AUTODIN access requirements.<br />
a. Review telecommunications service request (TSR).<br />
b. Review telecommunications service order (TSO).<br />
c. Develop or interpret SAR/GAR.<br />
6. Prepare system diagram, network diagram, and OPORD appendix.<br />
7. Identify user communities (R, U, and Y).<br />
8. Obtain Y routers, TCC, and TRC codes.<br />
9. Prepare database.<br />
10. Identify sensitive compartmented information facility (SCIF) activation and deactivation<br />
requirements/procedures.<br />
11. Determine crypto-key requirements, distribution plan, and crypto-key variable management plan.<br />
Performance Measures GO NO GO<br />
1. Determined availability of resources. —— ——<br />
2. Coordinated higher and adjacent system interface connectivity. —— ——<br />
3. Determined switching equipment interface and connectivity requirements. —— ——<br />
4. Determined subscriber terminal interface and connectivity requirements. —— ——<br />
5. Determined network AUTODIN access requirements. —— ——<br />
a. Reviewed TSR.<br />
b. Reviewed TSO.<br />
c. Developed or interpreted SAR/GAR.<br />
6. Prepared system diagram, network diagram, and OPORD appendix. —— ——<br />
7. Identified user communities (R, U, and Y). —— ——<br />
8. Obtained Y routers, TCC, and TRC codes. —— ——<br />
9. Prepared database. —— ——<br />
10. Identified SCIF activation and deactivation requirements/procedures. —— ——<br />
3-10
Change language